Troubleshooting Your Analyzer; Resetting And Powering The Analyzer Completely Off; Forcing Power Off; Resetting The Analyzer - Fluke OptiView Getting Started Manual
Wireless network analyzer
Hide thumbs
Also See for OptiView:
- Getting started manual (33 pages) ,
- Getting started manual (30 pages)
Table of Contents
Advertisement
®
OptiView
Getting Started Guide
Troubleshooting Your Analyzer
Resetting and Powering the Analyzer Completely Off
If you suspect the Windows environment has locked up, you may have to reset
the OptiView Integrated Network Analyzer. This is done by pressing the Reset
button. If you are not sure if the Windows environment or the analyzer
(hardware) has locked up, you may have to completely power down the analyzer
by forcing the power off as described below.
Forcing Power Off
Power can be forced off by pressing and holding the On/Off button for
approximately 7 seconds.
Resetting the Analyzer
The Reset button resets the Windows portion of the analyzer without shutting
down the data acquisition board. The Reset button should only be used if the
Windows environment has stopped responding.
12
Reset button
apo05f.eps
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiView and is the answer not in the manual?
Questions and answers