Troubleshooting Your Analyzer; Resetting And Powering The Analyzer Completely Off; Resetting The Analyzer; Forcing Power Off - Fluke OptiView Getting Started Manual

Wireless network analyzer

Hide thumbs Also See for OptiView:

Table of Contents

OptiView

Getting Started Guide

Troubleshooting Your Analyzer

If you suspect the Windows environment has locked up, you may have to reset the

analyzer. This is done by pressing the Reset button. If you are not sure if the

Windows environment or the analyzer (hardware) has locked up, you may have to

completely power-down the analyzer by forcing the power off as described below.

The Reset button resets the Windows portion of the analyzer without shutting

down the data acquisition board. The Reset button should only be used if the

Windows environment has stopped responding.

Power can be forced off by pressing and holding the On/Off button for

approximately 7 seconds.

Figure 13. Reset Button Location

Reset button

apo05f.eps

Table of Contents

Do you have a question about the OptiView and is the answer not in the manual?