Fluke OptiView Getting Started Manual page 17

Index
(continued)
Installing the Software on the Analyzer
After the file OPVWNA-V3.EXE has been copied to the
analyzer (preferably to the D: drive), perform the
following steps to complete the installation:
Note
The Wireless Network Analyzer PCMCIA Card must NOT
be installed in the analyzer during the software
installation. After the software installation, the card can
be inserted into the PCMCIA slot. Windows will then
detect the card and add it as new hardware using the
correct driver.
Use the Integrated Network Analyzer's Windows
Explorer to navigate to the directory where the
OPVWNA-V3.EXE file has been stored.
Double-click on the OPVWNA-V3.EXE file to run it.
Follow the InstallShield Wizard instructions to install
the software. Reboot the analyzer as indicated in the
InstallShield Wizard.
Note
If a previous version of the application is already
installed, follow the InstallShield instructions to remove
it. After rebooting the analyzer to finish the removal,
start at step 1 to install the OPVWNA-V3.EXE file.
Use one of the following methods:
7