Mounting/Removing Wheel - Grizzly G0763 Owner's Manual

8. Mark a line on wheel at six o'clock position to
mark heaviest side of wheel assembly.
9. Center nearest weight with line from above
step and secure it in place. This weight will
remain in place during following steps.
10. Position remaining two weights evenly around
sleeve groove.
11. Place wheel assembly on balancing base.
Wheel assembly should not rotate if weights
are in correct positions.
— If wheel assembly does rotate, reposition
two weights from Step 10 and repeat this
step until wheel assembly no longer rotates
when placed on balancing base.
12. When you are satisfied with wheel balancing
settings, install wheel assembly on machine
and test run for 5 minutes to verify balance.
— If any wobble is detected in wheel as it
rotates on machine, repeat this procedure
until it does not.
13. To make sure entire width of wheel edge is
parallel to table, redress wheel as instructed
in Wheel Dressing on Page 30.
-28-
Mounting/Removing
Wheel
Before mounting a grinding wheel (new or used),
perform the following procedures:
• Wheel Inspection (Page 26)
• Ring Test (Page 26)
• Wheel Balancing (Page 27)
Do not use a wheel that is suspected of having
cracks, or if you can see chips, nicks, or dents in
the wheel surface. These conditions can lead to
wheel failure where the wheel flies apart at oper-
ating speed. Always be sure to use a wheel that
is rated for operating at speeds of at least 3450
RPM.
Mounting Wheel
Items Needed
Grinding Wheel 7" D x
Wheel Sleeve .................................................... 1
Wheel Flange .................................................... 1
Wheel Flange Wrench ....................................... 1
Arbor Nut ........................................................... 1
Wrench or Socket 19mm ................................... 1
To mount wheel assembly:
1. DISCONNECT MACHINE FROM POWER!
2. Insert wheel sleeve into wheel (see Figure 33
for component identification).
Wheel
Sleeve
Balancing
Weight
Arbor
Figure 33. Wheel assembly components.
Model G0763 (Mfd. Since 6/15)
Qty
⁄ " W x 1 ⁄ " Bore ......... 1
1 1
2 4
Wheel
Flange
Arbor
Nut
Grinding
Wheel