Network Transient Protector - Eaton Powerware 9125 Two-in-One UPS 2500 User Manual

Network Transient Protector

The network transient protector, shown in Figure 38, is located on the
rear panel and has jacks labeled IN and OUT. This feature
accommodates a single RJ-45 (10BaseT) network connector.
Low voltage models can also accommodate an RJ-11 telephone
connector that provides protection for modems, fax machines, or other
telecommunications equipment. As with most modem equipment, it is
not advisable to use this jack in digital PBX (Private Branch Exchange)
environments.
NOTE DO NOT connect any telephone or fax/modem equipment to the 230V models; only
network protection is available for 230V models.
1.
2.
EATON Powerware
Connect the input connector of the equipment you are protecting to
the jack labeled IN.
Connect the network or telephone cable (low voltage models only)
to the jack labeled OUT.
Figure 38. Network Transient Protector
®
9125 Two-in-One UPS (2500/3000 VA) User's Guide
ADDITIONAL UPS FEATURES
IN
OUT
S
164201374 Rev D
www.powerware.com
49