Eaton Powerware 9125 Manual

How to Replace Internal Batteries
Pull the battery out onto a flat, stable surface. The battery is unsupported when you pull it
out of the UPS.
To replace the UPS internal batteries:
1.
NOTE DO NOT attempt to open the left side.
2.
3.
®
EATON Powerware 9125 Two-in-One UPS (700–2000 VA) User's Guide
Remove the UPS front cover (see Figure 29).
Figure 29. Removing the UPS Front Cover
Unscrew and set aside the battery retaining bracket (see Figure 30).
Disconnect the battery cable from the UPS battery connector and
remove the battery cable from the wire clips.
Battery Retaining Bracket
Figure 30. Accessing the UPS Internal Battery
S
UPS MAINTENANCE
C A U T I O N
Wire Clips
164201514 Rev B www.powerware.com
Battery
Connector
49