Configuration - Eaton Powerware 9125 Two-in-One UPS 2500 User Manual

Chapter 5
EATON Powerware

Configuration

When the UPS is in Configuration mode, the bar graph indicators
represent the configuration options. Use the control buttons
(On button and button) to modify the UPS configuration. Figure 33
shows the LEDs and Table 2 explains the corresponding options.
NOTE The UPS can be configured while in Battery mode. If the UPS transfers to battery
power while in Configuration mode, the UPS remains in Configuration mode and indicates
Battery mode on the front panel after exiting Configuration mode.
To reconfigure the UPS default settings:
1. Press and hold the On button and the
for one beep. The UPS transfers to Configuration mode.
The LEDs flash briefly and then display the enabled options.
2. Press the On button to scroll through the options. Each time you
press the button, the UPS beeps. The LED for the selected option
indicates the current setting; flashing represents disabled options
(see Figure 33 and Table 2).
Scrolling past the last LED returns to the first configuration option.
If you press the On button and nothing happens, the UPS is still in
Operation mode. Repeat Step 1 to enter Configuration mode, and
then perform Step 2.
3. Press the button for approximately one second to select the
Voltage option or to toggle the Site Wiring Fault Alarm or AC Input
Failure Alarm on or off.
NOTE The UPS exits Configuration mode automatically after two minutes of inactivity.
4. Press and hold the On button and the
exit Configuration mode at any time.
®
9125 Two-in-One UPS (2500/3000 VA) User's Guide
button simultaneously
button simultaneously to
S
164201374 Rev D
www.powerware.com
41