Connecting An External Poe Power - Siemens RUGGEDCOM RSG920P Installation Manual

RUGGEDCOM RSG920P
Installation Guide
Figure 7: Terminal Block Wiring - Connecting a Single DC Power Supply Input
1. Main Power Terminal Block
Figure 8: Terminal Block Wiring - Connecting Dual DC Power Supply Inputs
1. Main Power Terminal Block
2. Connect the negative wire from the power source to the negative terminal on the terminal block.
3. Connect the ground wire to the chassis ground terminal on the device.
Section 2.3.3

Connecting an External PoE Power

The RUGGEDCOM RSG920P supports four 10/100/1000 Mbps Power-over-Ethernet (POE) Ports that require
external power.
Connecting an External PoE Power
2. Chassis Ground Terminal
2. Positive Terminal 3. Negative Terminal
2 3
1
3. Negative Terminal 4. Positive Terminal
2 3
1
4. Chassis Ground Terminal
Installing the Device
4
4 3 2
Chapter 2
11