Configuring Ck60 Parameters; Configuring With The Setup Assistant - Intermec CK60 User Manual

Script Command Description
EXEC Launches a specified program and waits up to 10 minutes for it to complete.
CALL Processes a specified file of commands, returns. When you use the CALL command, the
execution of the current file pauses while a new file that follows the same set of commands
executes. Once the new file completes executing, AutoRun.exe continues processing the current
file.
CHAIN Processes a specified file of commands and does not return. This command calls another file
that follows the same set of commands and stops processing the current file.
RUN Loads a specified program and executes it. Specifies the show window attribute so that the user
interface is visible when the application launches.
LOAD Loads a specified program and executes it. Specifies the hide window attribute so the user
interface is hidden initially.

Configuring CK60 Parameters

Configuring with the Setup Assistant

CK60 Series Handheld Computer User's Manual
To create and install the AUTORUN.DAT file on your CK60 Computer
1 On the CK60 Computer, create a folder called "2577."
2 On your desktop, open the Notepad application.
3 Write commands for AUTORUN.DAT using these supported script
commands:
4 Save this Notepad file as AUTORUN.DAT.
5 Copy the AUTORUN.DAT file to the "\2577" folder on your CK60
Computer.
During every boot, the system scans for AUTORUN.DAT in the "\2577"
folder.
Here is a sample AUTORUN.DAT file that runs a dialer application and
connects to a VPN:
EXEC "\Program Files\My Dialer\Dialer.exe" 348-2600
EXEC "\Program Files\My VPN\Connect.exe" MyDomain
You can configure many parameters on the CK60 Computer, such as the
bar code symbologies it decodes or the network settings. These characteris-
tics are controlled by configuration parameters. The values you set for these
configuration parameters determine how the computer operates. Use con-
figuration commands to configure the CK60 Computer.
When first setting up the CK60 Computer, use the Setup Assistant to set or
enable basic network parameters and connect your CK60 Computer to the
network.
Chapter 3 — Configuring the CK60 Computer
49