Power Supply Unit - Furuno FAR-3210 Installation Manual

2. WIRING
2.4

Power Supply Unit

This procedure shows how to wire the power supply. For details see the interconnec-
tion diagram.
1. Connect the ground wire between the ground terminal on the chassis and the
ship's earth.
Note: Electrical shock can result if the ground wire is not connected properly.
2. Unfasten five screws to open the cover of the power supply unit.
3. Unfasten two screws from the cable clamp to separate the cable clamp assembly.
4. Pass the LAN and serial cables through the cable clamp.
1. Insert the cable. 1. Insert the cable.
2-24
Cable clamp
Cable clamp
2. Pass the cable 2. Pass the cable
to next lane. to next lane.
LAN cable
Ground terminal
Set the cable. Set the cable.
Serial cable