Antenna Unit - Furuno FAR-3210 Installation Manual

2. WIRING
2.2

Antenna Unit

Three cables are connected to the antenna unit: antenna cable, cable for the sub mon-
itor (option) and power cable for the deicer (option). The procedure shows how to con-
nect all cables. Disregard the descriptions for the optional equipment if not applicable.
2.2.1 How to fabricate the cables
Antenna cable RW-00135
The end of the antenna cable RW-00135 which connects to the antenna unit is pre-
fabricated.
Antenna cable RW-9600 (for retrofit or foremast installation)
The white, red, and green wires are not used. Attach a single crimp-on lug (FV5.5-
S4(LF), yellow, supplied locally) to the wires. (These wires will be connected together
with the shield of the power line, in the next section.)
Sheath Sheath
Cable RW-00136 (for a sub monitor)
Note: The maximum cable length is 50 m.
Sheath Sheath
2-4
Armor (clamp with cable clamp.)
Vinyl tape
Sheath
36 5
Armor (clamp with cable clamp.)
Vinyl tape
Shield
36 5
14
14
5 9
Crimp-on lug
330 330
9
5
6
Shield Shield
Crimp-on lug
Coaxial Coaxial
cable cable
6
Braided shield
Coaxial cable