Monitor Unit; Mounting Considerations - Furuno FAR-3210 Installation Manual

2. WIRING
15. Pull up the plastic cover and connect the power cable.
16. Remount the connector cover for the power cable.
17. Reattach the cover of the power supply unit.
2.5

Monitor Unit

For the wiring of the monitor unit, see the operator's manual supplied with the monitor
unit. Also, for resolution and image data output settings, see the Instruction Manual
(E32-01305-*).

Mounting considerations

Standard type
• Connect the radar main monitor to the DVI1 and COM1 ports.
• Connect the sub radar monitor to the DVI2 and COM2 ports.
VDR connection
To connect a VDR, it is necessary to output data in analog format. See the Instruc-
tion Manual (E32-01305-*). To connect a VDR to the DVI3 port, use the optional
DVI-BNCX5-L2000 cable to output the RGB signal from the DVI-I. See the opera-
tor's manual supplied with the VDR. Adjustment of the output is necessary.
Menu Setting
The [INSTALLATION SETTING] menu appears only when the power is turned on for
the first time after installation of the monitor unit.
INSTALLATION SETTING
EXT BRILL CTRL
SERIAL BAUDRATE
COLOR CALIBRATION
KEY LOCK
SAVE AND EXIT
Adjust the settings referring to the following table.
EXT BRILL
CTRL
RS-485
*: [DVI PWR SYNC] is the slide switch at the bottom rear of the monitor unit. Confirm
that this switch is set to [ON] (default setting). See Slide switch below for details.
2-28
RS-485 (OFF/DVI1/DVI2/RS-232C/RS-485/USB)
4800bps (4800/9600/19200/38400)
ON (OFF/ON)
ON (OFF/ON)
YES (NO/YES)
SERIAL BAUD
RATE CALIBRATION
4800bps
Menu
COLOR KEY
LOCK
ON ON
Menu item
DVI PWR
SYNC*
ON