Furuno FAR-3210 Installation Manual page 88

2. WIRING
6. Reattach the control unit cover.
7. Unfasten four screws (M4 8) to remove the processor unit cover.
8. Unfasten the three bolts circled below to remove the cable clamp (upper) as
shown below.
J11 J11
Unfasten this bolt to use Unfasten this bolt to use
the lower clamp holes. the lower clamp holes.
9. Disconnect the control unit cable from the processor unit, then connect the cable
assy (6TPSH-XH12X2-LxxSP2).
10. Set the shields of cables under the cable clamp then tighten the cable clamp.
11. Remount the processor unit cover.
2-60
Cable assy
J5 J5 J8 J8
J3 J3
J12 J12
J6 J6 J9 J9
J4 J4
J14 J14
J7 J7 J13 J13
J10 J10
Unfasten these three bolts to remove the upper plate.
Shield
Cable clamp
Circuit board
Clamp holes
(upper)
Clamp holes
(lower)
Lay shields of cables
under this clamp then
tighten the clamp.