Table of Contents
Advertisement
Receiver (Amplifier) Hookups
This connection is for listening to the sound through
speakers (2ch–L, R) connected to a receiver. Refer as well
to the instructions supplied with the component to be
connected.
Set "SUBWOOFER" in "SPEAKER SETUP" to "NONE" in
the setup display (page 57).
z
You can enjoy surround sounds even if you connect front
speakers only
You can use 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without using actual
rear speakers (Virtual Enhanced Surround). For details, see page
39.
CD/DVD player
To an AC outlet
AC power cord (supplied)
: Signal flow
16
WOOFER
OUT
R – AUDIO – L
DC IN 10.5V
AC power adaptor
(supplied)
Required cords
Audio connecting cord (not supplied) (1)
White (L)
Red (R)
S video cord (supplied) (1)
When connecting the cords, be sure to match the color-coded
cord to the appropriate jacks on the components: Red (right) to
Red and White (left) to White. Be sure to make connections firmly
to avoid hum and noise.
1
2
OPTICAL
COAXIAL
PCM/DTS/
DOLBY DIGITAL (AC – 3)
/MPEG
VIDEO
S – VIDEO
LINE OUT
To LINE
To LINE
OUT
OUT
(AUDIO)
(S-VIDEO)
To S VIDEO
input
To audio input
Note
You cannot enjoy the picture with S video signal if your TV is not
conformed to the S video signal. When your TV does not have S
VIDEO input, connect the component via the VIDEO INPUT
connector using the video connecting cord (not supplied) instead
of the S video cord. For details, see page 14.
Refer to the instructions supplied with your TV.
White (L)
Red (R)
TV
INPUT
S VIDEO
Receiver (Amplifier)
CD
L
R
Advertisement
Table of Contents
