Controlling Your Tv Or Av Receiver (Amplifier) With The Supplied Remote - Sony DVP-F11X Operating Instructions Manual

Controlling Your TV or AV Receiver (Amplifier) with the
Supplied Remote Z
If you adjust the remote signal, you can control your TV
with the supplied remote. The default setting is to control
Sony TVs with the mark.
When you connect the player to a Sony AV receiver
(amplifier), you can also set the input of the receiver
(amplifier) to this player with the supplied remote .
TV/DVD
switch
1 2
4 5
Number
7 8
buttons
0
Controlling TVs with the remote
1
Slide the TV/DVD switch to TV.
2
Hold down ?/1 (POWER), and enter your TV's
manufacturer's code (see the table) using the
number buttons. Then release ?/1 (POWER).
Manufacturer Code
number
Sony (default) 01
Aiwa 32
Akai 68
Blaupunkt 10, 21
Ferguson 52
Gold Star 03, 04
Grundig 11
Hitachi 24
JVC 33
Loewe 45
Mitsubishi 27, 28, 50
Miver 09
NEC 66
58
?/1 (POWER)
3
6
9
Manufacturer Code
number
Nokia 69
Orion 47, 48
Panasonic 17, 49
Philips 06, 08
Pioneer 26
Saba 12, 13
Samsung 23
Sanyo 25
Sharp 29
Siemens 39
TEAC 67
Thomson 43
Toshiba 38
Code numbers of controllable TVs
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV.
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may reset to 01 (Sony). Reset the appropriate code number.
When you set the TV/DVD switch to TV, you can control
your TV using the keys below.
TV/DVD switch
1 2
4 5
7 8
0
You can
By pressing
Turn the TV on or off
?/1 (POWER)
Select the input source for the TV
TV/VIDEO
between the TV and VCR
Adjust the volume of the TV
VOL
Select the channel of the TV
TV CH
Switch the wide picture on or off
WIDE MODE
Note
Depending on the TV, you may not be able to control your TV or
to use some of the buttons above.
?/1 (POWER)
3
WIDE MODE
6
9 ENTER
TV/VIDEO
TV CH
VOL
ENTER