Receiver (Amplifier) Hookups
Connect your receiver (amplifier) as follows.
Refer as well to the instructions supplied with the
component to be connected.
You can enjoy surround sounds even if you connect front
You can use 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without using actual
rear speakers (VES: Virtual Enhanced Surround and VIRTUAL
SEMI MULTI DIMENSION). For details, see page 34.
Audio connecting cord (not supplied) (1)
S video cord (supplied) (1)
FRONT REAR CENTER
OUT (R, L)
: Signal flow
S VIDEO OUT
To S VIDEO
Take off the
To optical digital input
To coaxial digital input
To audio input
When connecting the cords, be sure to match the color-coded
cord to the appropriate jacks on the components: Red (right) to
Red and White (left) to White. Be sure to make connections firmly
to avoid hum and noise.
If you have a digital component such as a receiver (amplifier)
with a digital connector, DAT or MD, connect the component via
the DIGITAL OUT OPTICAL or COAXIAL connector using an
optical or coaxial digital connecting cord (not supplied).
Optical digital connecting cord (not supplied) (1)
Coaxial digital connecting cord (not supplied) (1)
Do not connect the power cord to a switched AC outlet
such as the AC outlet on a receiver (amplifier). Doing so
may cause the Playback Memory and menu settings to be
cancelled when you turn off the receiver.
COMPONENT VIDEO OUT
To S VIDEO
To an AC outlet
deck, DAT deck,