Table of Contents
Advertisement
Accessories Description
Aileron push rod Installation
1.Use a servo tester or radio to
center the servo.
2.Use glue to secure the servo and
aileron control horn to the main wing.
3.Feed the servo wires through the
trough. After all the servos and
cables are installed, apply the decal.
4.Insert one end of the pushrod
into the servo arm and adjust its
length.
Snap the clevis over the ball link on
the control horn.
5.Repeat the above four steps for
the other wing.
Elevator push rod Installation
1.Use a servo tester or radio to
center the servo.
2.Use glue to secure the servo and
elevator control horn to the
Horizontal stabilizer.
3.Feed the servo wire through the
trough, after all the servos and
wires are installed apply the decal.
4.Insert one end of the pushrod into
the servo arm and adjust its length,
then snap the clevis over the ball
link on the control horn.
5.Repeat the above four steps for the
other side.
Rudder push rod Installation
1.Use a servo tester or radio to
center the servo.
2.Use glue to secure the servo
and rudder horn to the
Vertical stabilizer.
3.Feed the servo wire through
the trough, after the servo
and wires are installed apply
the decal.
4.Insert one end of the pushrod
into the servo arm and adjust
its length. Snap the clevis
over the ball link on the
control horn.
-�m�DEL
rlCCWlng
A- Servo
B- Aileron control horn
C- Main wing push rod
D- Main wing servo trough
E- Ribbon wire
A- Servo
B- Elevator control horn
C- Elevator push rod
D- Servo cable port
A- Servo
B- Rudder control horn
C- Rudder push rod
For best results, apply the glue and
wait for 90 seconds, then slide the
piece in place.
A
EN
This kit contains EPO Glue
AVANTI S
ltem No.:FJ21211
Hide quick links:
Advertisement
Table of Contents
