Replacing The Fsx 1600 Fan Assemblies - Brocade Communications Systems FastIron SuperX Hardware Installation Manual

6

Replacing the FSX 1600 fan assemblies

FSX 1600
Replacing the
NOTE
To replace the fan assemblies in the FSX 1600-ANR chassis, refer to
fan assemblies"
The FSX 1600 has two fan assemblies, both accessible from the rear. Each assembly has a fan
which pulls warm air out of the chassis.
You can remove and replace a fan assembly while the FSX 1600 chassis is powered on and
running.
To replace the fan tray, you need the following:
•
•
•
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm resistor.
To replace a fan assembly, perform the following tasks.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector
2. Using the flathead screwdriver, loosen the four captive screws that secure the fan (marked
154
fan assemblies
on page 155.
A new fan assembly, which you can order from Brocade
An ESD strap (provided with the fan assembly kit) or an ESD wrist strap with a plug for
connection to the ESD connector on the chassis.
In addition to the above, you might also need a #2 Phillips-head screwdriver.
located in the top right corner of the chassis front.
"Fan A" or "Fan B") to the chassis rear.
"Replacing the FSX 1600-ANR
Brocade FastIron X Series Chassis Hardware Installation Guide
53-1001723-02