Error Responses; Using The Command And Response Tables - Extron electronics StudioStation 100 User Manual

Error Responses

When the StudioStation 100 is unable to execute the command, it returns an error response
to the host. The error response codes and their descriptions are as follows:
– Unrecognized command
E10
– Invalid port number
E12
– Invalid parameter (number is out of
E13
range)
– Not valid for this configuration
E14
– Invalid command for signal type
E17
– System timed out
E18

Using the Command and Response Tables

The Command and Response Table
represent variables in the command and response fields. Command and response examples
are shown throughout the table. The SIS commands are not case sensitive. The ASCII to
Hex conversion table below is for use with the command and response table.
Space
Figure 70.
ASCII to Hex Conversion Table
ASCII to Hex Conversion
StudioStation 100 • Remote Communication and Control
– Busy
E22
– Privilege violation
E24
– Device not present
E25
– Maximum connections exceeded
E26
– Bad file name or file not found
E28
begins on page 75. Symbols used in the table
•
71