Cisco DX70 Administrator's Manual page 63

Hide thumbs Also See for DX70:
Table of Contents

Advertisement

Cisco DX70 and DX80
Introduction
Factory reset the video system
We recommend that you back up the log files and configuration of the
video system before you continue with the factory reset.
Factory reset DX70 using the mute and volume
buttons
Follow these steps to factory reset a DX70 on boot up. If the video system
is on, press and hold the power button until the system shuts down before
you continue.
1. Locate the
Mute
and
Volume up
buttons (LEDs).
2. Press the power button, and pay attention to the
3. When the
Mute
button has blinked twice, press the
immediately followed by pressing and holding the
approximately 4 seconds. During this process the
red for a few seconds.
Wait while the video system reverts to the default factory settings. The
video system restarts automatically when finished. This may take a few
minutes.
When the system has been successfully reset to factory settings, the
Setup assistant starts with the Welcome screen.
D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration
Peripherals
(page 3 of 4)
Mute
button.
Volume up
button,
Mute
button for
Mute
button turns
Maintenance
Maintenance
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
63
Administrator Guide
System settings
Appendices
Mute
Volume up
Power button

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dx80

Table of Contents