Hot Cabinet - Electrolux STARLINE LARGE 249 Operating And Safety Instructions Manual

20

8. HOT CABINET

The hot cabinet is integrated in the base unit of the
relevant appliance. It has an electric heating, sliding or
leaf doors, shelf supports and shelves. The entire
appliance is made of stainless chrome nickel steel. The
electric power is 1 kW for the 500 mm wide element and
2 kW for the 800 and 1000 mm wide elements.
Operation
only one-sided from the front.
Control knob and operation lamp
Putting into operation for the first time
The cabinet should be heated up for 1 hour at 80 °C with
the door closed. Then allow to cool completely with the
door open.
Standby
The empty cabinet should be preheated for at least 45
minutes with the doors closed. When the steady state has
been reached, the appliance is ready for loading. Ensure
that the doors are opened only for loading or for removal.
Operating Instructions STARLINE Ranges
1 Upper part of the range
2 Base unit = Hot cabinet
3 Operation lamp (green)
4 Control knob
5 Wing doors
The entire heating system is switched-on by means of a
control switch on the control panel. The temperature in
the hot cabinet can be set and regulated steplessly
between 30 and 110 °C. The required level is obtained
by turning the knob in the clockwise direction to the mark
located above on the control panel.
When the appliance is switched-on, the green operation
lamp lights up.
The hot cabinet is switched-off when the control knob is
at 0. The green operation lamp goes out.
Safety precautions
When the maximum temperature is set, the articles in the
cabinet can reach 100 to 110 °C. The articles must not be
touched without protective measures because there is a
risk of injury to the operator through burns.
Cleaning
The surfaces of the hot cabinet are made of chrome nickel
steel. They should be washed with hot soapy water
containing a normal, fat-removing cleaner and should be
rubbed dry.
Steel brushes, steel wool, copper cloths, etc. must not be
used.