Table of Contents
Advertisement
14
Cleaning
See section: Ceramic hobs.
Filter:
The exhaust air of the induction generator is led off with a
fan. The opening is in the base in the end cover and is
covered with two filters. To assure a faultless operation
attention must be paid that these does not obstruct.
The filters should be removed at regular
intervals and be cleaned with a dishwashing
liquid.
5.3.
ERRORS
If an error occurs in the appliance, it will be displayed by
pulsation of the green operation lamp. The series of
pulsation shows the kind of error. Between two long
Code = amount of short
lamp signals
no signal
1
2
3
4
5
6
7
Operating Instructions
Error
no fault, normal operation
no
coil
current,
hardware
overcurrent
too high coil current, software
overcurrent
temperature
of
cooling
element too high
temperature of cooking zone
too high, interruption of the
cooking zone sensor
power switch has a cable
breakage
internal temperature of the
appliance too high
short circuit of the cooking
zone sensor
STARLINE Ranges
Filter Full surface induction
shinings of the lamp there is an amount of short shining
signals. The amount of short signals gives the code of the
error.
none
if the error signal remains after several starts: summon
service agent
if the error signal remains after several starts: summon
service agent
wait until the appliance has cooled down, clean air filter
of the fan, switch on again
wait until the appliance has cooled down, set power
switch to 0 and start again;
if the error signal remains after several starts: summon
service agent
summon service agent
wait until the appliance has cooled down, reduce
ambiant temperature
the appliance will continue to function normally but the
temperature of the cooking zone is no longer being
monitored; summon service agent
Action
Advertisement
Table of Contents
