EMS EkoMini Operator's Manual page 27

G. Set Delay for dialing out Telephone Number 2 after 1. RP 2 DLAY
(Dial Delay in minutes from Telephone Number 1, 0-999)
H. Set Report 3 Dial out Telephone Number.
(Dial out Number. 20 digits)
I. Set The Pin Number (if Applicable).
(Pin Number. 10 digits, maximum)
J. Set delay for dialing out Telephone Number 3 after 2.
(Dial Delay in minutes from Telephone Number 2, 0-999)
K. Activate Report Alarms Command
(Answer, Yes)
L. Set Answer Rings
(Answer Rings. 0-999, Default = 2)
M. Set Time
(format: 01:31:29 for 1:31 am or 13:31:29 for 1:31 pm)
N. Set Date
(format: 01/10/99 for Jan 10, 1999)
O. Turn on the Remote Alarming
(Note: This last command is necessary, or no alarms will be reported.)
Note: Report 1 Dial is the number that the EkoMini
condition occur. If desired, the Report 2 Dial and Report 3 Dial can be set to
different Telephone Numbers. The Report 2 and Report 3 have by default a
cumulative delay set to 5 minutes each. After 5 minutes of an alarm state,
Report 1 will be contacted. After 5 more minutes, Report 2 will be contacted and
after 5 more minutes (or 15 minutes after the original alarm), Report 3 will be
contacted. If the Report 2 and Report 3 Dial out numbers are not changed, the
TM
EkoMini will attempt to contact Report 1 when the delay time has expired. After
setting up the Dial Out number and if necessary the Pin number (used for some
paging systems)
P. Testing the remote alarming.
EMS Wireless EkoMini Manual
27
EMS Wireless
RP 3 DIAL
RP 3 PINN
RP 3 DLAY
RP ACTY
AR
TM
DT
SET RP ACTV=YES
TM
will dial should an alarm
test report 1