List Of Options; Installation Guidelines; Unpacking; Additional Parts Needed For Installation - EMS EkoMini Operator's Manual

2.0 List of Options

The only available option is the remote alarm modem and software.

3.0 Installation Guidelines

3.1 Unpacking:

Remove the EkoMini
EkoMini repeater kit was purchased, donor and server antennas should have been
received in separate shipping containers.

3.2 Additional Parts Needed for Installation:

Since every installation is different, other parts may need to be provided by the
installer:
• Donor antenna, unless an EkoMini
• Server antenna(s), unless an EkoMini
• 50 ohm Coaxial power splitter, if more than one server antenna is needed.
• 50 ohm ½" flexible coaxial cable, plenum rated if required by building code.
• Type N male connectors (or DIN 7-16, depending on the antenna connector
option)
• Mounting hardware for the donor antenna
• Lightning surge suppressor
• Weatherproofing compound
• Other miscellaneous installation items

3.3 Pre-setting the Configuration Switches:

TM
The EkoMini is shown in Figure 3. It has a set of eight configuration "DIP" switches
located under a small removable panel. See Figure 4. For many installations, these
switches are set properly at the factory. However, they can be verified or changed
using this procedure:
• Remove the small switch panel with a Phillips head screwdriver.
EMS Wireless EkoMini Manual
TM
repeater and the external power supply from the box. If an
14
TM
kit was purchased.
TM
kit was purchased.
EMS Wireless