Switches 1 And 2: Uplink Gain Offset - EMS EkoMini Operator's Manual

• The switches are numbered 1 through 8, as shown in Figure 2 below. They can
be turned "on" or "off" using a small screwdriver or a bent paper clip. Note that
each switch is "off" when it is pushed "up" toward the repeater mounting flange.
• Position each of the eight switches as described below.
Re-Rad (Server) Antenna
Port (rear panel)
Model
Number
Sticker
Mounting Flange
Rerad Connector

3.3.1 Switches 1 and 2: Uplink Gain Offset

Pre-set these switches to "off". After initial power on tests, these switches can be
adjusted if necessary. See Section 5.2 for full details.
EMS Wireless EkoMini Manual
Configuration
Reset
Switch Removable
Button
Panel
Figure 3: EkoMini
Figure 4: EkoMini
15
DC Power
Signal
Connector
Level LEDs
Power "ON" Indictor
(Green)
TM
Repeater Illustration
OFF
1 2 3 4 5 6 7
ON
TM
Configuration Switches
EMS Wireless
Telephone
Connector
Alarm Indicator (Red)
Donor Connector
Reset
8
Donor
Antenna
Connector