Installing The Donor And Server Antennas; Figure 8: Ac Power Ok - Coaxial Cables Are Connected - EMS EkoMini Operator's Manual

Figure 8: AC power OK – coaxial cables are connected
• Four mounting holes are provided to mount the EkoMini
Allow access clearance to the small removable panel on the side of the repeater
near the model number sticker (for access to the configuration switches), the
reset button, the telephone connector jack (if remote alarming will be used), and
both coaxial connectors.
indicators, as shown in Figure 3.
• Select a location for the external power supply, such as a protected shelf, etc.
Plug the power supply into the AC outlet, but do not plug the power supply into
the EkoMini
server antennas are installed and connected.

3.5 Installing the Donor and Server antennas:

• Choose a donor antenna location that gives a line-of-sight path to the donor base
station, and install it according to the manufacturer's installation procedure.
• Install ½" flexible coaxial cable from the donor antenna to the "Donor" port of the
TM
EkoMini repeater.
• Install the server antenna per the antenna manufacturer's installation procedure.
• Install ½" flexible coaxial cable from the server antenna pigtail to the "Rerad" port
of the EkoMini
EMS Wireless EkoMini Manual
Mounting Flange
Rerad Connector
Also, make sure you can see the front panel LED
TM
at this time. Only apply power to the repeater after the donor and
TM
repeater.
21
EMS Wireless
Donor Connector
Reset
TM
to a wall or ceiling.