Switches 6, 7, And 8: Downlink Peak Power Limit; Installing The Ekomini - EMS EkoMini Operator's Manual

3.3.4 Switch 6, 7, and 8: Downlink Peak Power Limit
For initial power-up, turn all these switches "off". See Section 5.5 for full details.
This completes the configuration switch settings. Leave the cover off so adjustments
can be made later if needed.

3.4 Installing the EkoMini

Note: Only qualified technicians should perform the installation. The user is cautioned
that modification or changes to this device not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the
condition that this device does not cause harmful interference.
TM
The EkoMini is designed for indoor use only. It should not be mounted outside.
• Determine the donor and server antenna(s) locations. Choose a location for the
TM
EkoMini
maintaining adequate isolation.
electrical or telephone room so the EkoMini
The location must also be near a 100 - 240 VAC, 47 – 63 Hz outlet. See Figures
7 and 8 below – do not apply AC power without the coaxial cables and
antennas installed!
Figure 7: Do not apply power with the coaxial connectors disconnected!
EMS Wireless EkoMini Manual
TM
:
that will minimize coaxial cable lengths to these antennas, while
Mounting Flange
Rerad Connector
20
Also, choose a protected area such as an
TM
will not be physically damaged.
EMS Wireless
Donor Connector
Reset