Installing The Donor And Server Antennas; Installing The Remote Alarming Telephone Cable (Optional); Initial Power-Up - EMS EkoMini Installation Manual

connectors.
indictors, as shown in Figure 1.
• Select a location for the external power supply, such as a protected
shelf, etc. Plug the power supply into the AC outlet, but do not plug
the power supply into the EkoMini
to the repeater after the donor and server antennas are installed
and connected.

5.0 Installing the Donor and Server antennas:

• Choose a donor antenna location that gives line-of-sight coverage
back to the donor base station, and install it according to the
manufacturer's installation procedure.
• Install ½" flexible coaxial cable from the donor antenna to the
"Donor" port of the EkoMini
• Install the server antenna per the antenna manufacturer's
installation procedure.
• Install ½" flexible coaxial cable from the server antenna pigtail to the
"Rerad" port of the EkoMini
• Most common installations will provide enough electrical isolation
between the donor and server antennas. In general, keep the donor
and server antennas separated by more than 75 feet. If there is any
question whether the isolation is adequate in a particular
installation,
assistance.

6.0 Installing the Remote Alarming Telephone Cable (optional):

If the optional remote alarming is installed in the repeater, install a standard
telephone cable to the EkoMini
a dedicated telephone line. Remote alarming details are detailed in Appendix C.

7.0 Initial Power-up:

• Be sure the donor and server antennas and coax cables are
connected to the EkoMini
AC outlet, and the DC power cord into the EkoMini
Also, make sure you can see the front panel LED
TM
repeater.
TM
repeater.
contact EMS Wireless
TM
repeater using an RJ-11 connector. This should be
TM
. Then, plug the power supply into the
TM
at this time. Only apply power
Technical
TM
Support for
.