Configuring The Ipmi From The Netbackup Appliance Shell Menu - Symantec NetBackup 5230 Installation Manual
Hide thumbs
Also See for NetBackup 5230:
- Maintenance manual (69 pages) ,
- Troubleshooting manual (201 pages) ,
- Installation manual (57 pages)
Table of Contents
Advertisement
46
Verifying the operation of the appliance and configuring IPMI
Configuring the IPMI from the NetBackup Appliance Shell Menu
Configuring the IPMI from the NetBackup Appliance
Shell Menu
Number
Description
1
System ID button
2
NMI button (do not use)
3
eth0 NIC1 activity LED
4
eth2 NIC3 activity LED
5
System cold reset button
Check the power supply module LEDs on the rear panel. Each module has
one LED.
See Hardware verification and turning on the NetBackup 5230 appliance
and storage shelf" on page 43.
This section explains how to configure IPMI from the NetBackup Appliance Shell
Menu.
Number
Description
6
System status LED
7
Power button and LED
8
Hard drive activity LED
9
eth3 NIC4 activity LED
10
eth1 NIC2 activity LED
Advertisement
Table of Contents
Need help?
Do you have a question about the NetBackup 5230 and is the answer not in the manual?
Questions and answers