Interface Connections; Supplied Cables; Getting Started - Thinklogical VQM-USB030-LCTX Manual

Interface Configurations
All physical connections to the product use industry-standard connectors. Non-supplied cables that may
be needed are commercially available.
All USB 3.0 Transmitter and Receiver Modules are connected to each other via fiber-optic cables.
The transmitter connects to the CPU with a supplied USB 3.0 cable. The receiver provides an
interface to the USB 3.0 devices.
A USB 3.0 receiver connects to the peripheral USB devices
(storage device, camera, etc.) with USB-A 3.0 connectors. Fiber-
Optic Cables connect the Receiver to the Transmitter.

Supplied Cables

All USB 3.0 Transmitter Extenders will be supplied with a 2 meter USB 3.0 Cable CBL-000053-002MR.
USB 3.0 cables and ports are different from lower speed
USB cables and ports and can be distinguished by the
blue plastic inserts inside the connectors and plugs
and by the SuperSpeed "SS" logo.

Getting Started

Warning! USB 3.0 does not support SUSPEND modes of operation. As such, your
computer should be configured to NOT go into "suspend mode" or to "suspend"
the USB ports. Please refer to the following instructions for your operating system.
USB 3.0 Extender Manual
Transmitter
A USB 3.0 transmitter connects to the CPU/peripheral source through
a USB-B 3.0 connector. Fiber-Optic Cables connect the Transmitter
to the Receiver.
Receiver
thinklogical
®
Page 8
Rev. B, April 2017