Table of Contents
Advertisement
•
For Linux users, plug a USB 3.0 device into the Receiver Extender. Open a terminal and run the
"lsusb" command. The Extender should show up as a USB 3.0 hub device with a Vendor ID of
0000h and Product ID of 0000h.
•
If the device is not detected correctly, please consult the Troubleshooting Guide, below.
Troubleshooting Guide
The following table provides troubleshooting tips, arranged in the order in which they should be executed
in typical situations. If you're still having problems after trying these suggestions, please contact
Thinklogical Technical Support (1-203-647-8700) for further assistance. (See pg. 19)
USB 3.0 Extender Manual
thinklogical
®
Page 18
Rev. B, April 2017
Advertisement
Table of Contents
