Collocated Radios; Be Aware Of Seasonal Changes; Basic Remote Antenna Installation - Banner Sure Cross Performance GatewayPro DX80P*A6 series Instruction Manual

®
Sure Cross Performance DX80 Wireless I/O Networks

4.3.3 Collocated Radios

When the radio network's master device is located too close to another radio device, communications between all devices
is interrupted. For this reason, always assign a unique Network ID to your wireless networks. The Network ID (NID) is a
unique identifier you assign to each wireless network to minimizes the chances of two collocated networks interfering with
each other. Assigning different NIDs to different networks improves collocation performance in dense installations.

4.3.4 Be Aware of Seasonal Changes

When conducting the initial Site Survey, the fewest possible missed packets for a given link is better. However, seasonal
changes may affect the signal strength and the total signal quality. Radios installed outside with 50% missed packets in
the winter months may have 80% or more missed packets in the summer when leaves and trees interfere with radio
reception.
Figure 1. A good signal in winter doesn't always mean you will get the same signal strength the rest of the year.
Figure 2. During spring and summer, leaves may block more of the radio signal.

4.4 Basic Remote Antenna Installation

A remote antenna system is any antenna system where the antenna is not connected directly to the radio; coaxial cable
connects the antenna to the radio.
When installing a remote antenna system, always include a lightning arrestor or coaxial surge suppressor in the system.
Remote antenna systems installed without surge protection invalidate the warranty of the radio devices.
Surge suppressors should be properly grounded and mounted at ground level near where the cabling enters a building.
Install the surge suppressor indoors or inside a weatherproof enclosure to minimize corrosion or component deterioration.
For best results, mount the surge suppressor as close to the ground as possible to minimize the length of the ground
connection and use a single-point ground system to avoid creating ground loops.
For more detailed information about how antennas work and how to install them, refer to Antenna Basics (p/n 132113)
(also included as a chapter within the product manual).
www.bannerengineering.com - Tel: 763.544.3164 23