Insignia 9005 Assembly & Fitting Instructions page 8

Stage four.
You are now going to construct the front frame and glasses. Taking
the two cross supports, one fits at the top and one at the bottom,
note the curved edges fit towards each other so flat fact goes to
the shower tray and top cross member will be flat on the top to
accommodate the roof. We constructed these will carry the front
glasses and the door runners.
Starting with the lower one, locate the two screw holes in the side
glass as example below. Silicone along whole surface where the
tray will meet the lower cross support. And screw together. Repeat
the opposite end.
Screw into 2 x location
For the latest fitting instructions please visit www.insigniarange.co.uk
15
Yours will look similar to above
Joint will look similar to this
With the lower cross support firmly in place take the upper cross
member and repeat procedure but no sealing is required here!
Bottom joint should be neat and tidy as picture right for bottom
and left for top.
Taking now one of the two corner fascias (yours could be squared
not curved as picture) seal in the two channels and press firmly
over one front upright to fit as picture shows. Repeat other end.
When complete locate screw holes inside the cabin and taking a
white washer place the screw through it and firmly screw into each
pre drilled hole.
See overleaf......
For the latest fitting instructions please visit www.insigniarange.co.uk
16