Insignia 9005 Assembly & Fitting Instructions page 15

Connecting the steam generator
Fitted at the bottom of the shower rear you will find the steam
generator which will look similar to the picture below. Connect
white insulated hose to the shower steam pod. This is located
below the seat in the cabin and connection is at the rear for ease.
Check now by picture or words written on the generator box,
"Water In" This will connect to the middle braided hose found
coupled to the rear of the water valve you just tighten connec-
tions to. Finally if the fitting kit was purchased couple the last con-
nection which is "Steam Generator water waste" This goes from
the generator to the shower tray spigot mentioned at the earliest
stage (Remember? You drilled this out!). If no waste purchased
you will need to make your own arrangements to connect some-
where else into the house waste or call 0844 800 3069 to order
the special waste. Remember to tighten all connections
See typical set up overleaf.....
For the latest fitting instructions please visit www.insigniarange.co.uk
29
Important!
Never use the steam
generator with the vent
holes pointing towards
the shower wall or a
person.
Never use the steam
outlet in the closed posi-
tion. This excessive heat
will damage your tub
and this is NOT covered
under your warranty
terms.
What Should I Know About Steam Room Safety?
Please visit the following link:
http://www.insigniarange.co.uk/instructions/
Steam_Safety_Please_Read.pdf
Checked neoprene seals are in
For the latest fitting instructions please visit www.insigniarange.co.uk
Water In
Steam Out
Drain/Water Out
Steam Outlet
30