Insignia 9005 Assembly & Fitting Instructions page 10

With trim on the glass edge take glass and press firmly into the up-
right channel. Repeat the other front end. You now have the two
front side glasses fitted in place. To retain the glass take small
screws provided and locate in the bottom cross section support
both sides. Screw tightly in place as picture below shows. Repeat in
the top sections also.
Screw to retain front glass
For the latest fitting instructions please visit www.insigniarange.co.uk
19
Stage five Door Assembly
NOTE: Identify the doors left and right up and down. Door magnets
attract then you have it correct. Repel and you have one round the
wrong way!
Taking the 8 x door wheels place through glass with wheel tyres on
outside of doors. While still loose offer into the door runners (two
person job in case a door should fall out of runner!) When located
tighten but NOTE: All wheels are eccentric and you adjust these to
give a correct smooth running alignment. At the same time close
the two doors together and make sure the door magnets are tight
the full length and aligned squarely.
Door wheels, adjust, tighten then place white cap on
Door running smoothly? Both aligned? Now fix the 2 x door han-
dles on.
For the latest fitting instructions please visit www.insigniarange.co.uk
20