Insignia 9005 Assembly & Fitting Instructions page 7

Stage two
Taking the left column with control panel on (as you look from the
front) and the centre panel, align one to the other and drill four
equally spaced holes to through the edge as they will join. Offer
these up to the correct position on the shower tray. Taking the
right jet massage column repeat the same procedure. Your will
now have the three back sections drilled ready to screw. Taking the
silicone sealer now joint each mating vertical surface making sure
the sealer will be on the shower internal side of screws. If this is
not undertaken water will ingress and leak through threads. Screw
all self tappers into the holes you drilled and make sure you have a
firm seal. Now offer this section onto the shower tray and note
the position it will fit with each side aligned to tub. Remove off the
tray and silicone seal along the area the frame is about to fit to.
When done place the frame on the tray, drill holes approx 30 cm
apart and screw the frame to the tray as you did wall to columns.
NOTE: This is a 2 person job as parts are heavy!!!
This is stage two complete.
For the latest fitting instructions please visit www.insigniarange.co.uk
13
Stage three.
Taking the left hand side glass this needs fixing to the column and
is undertaken as so in picture. Offer the wider edge up to the col-
umn front end. Seal along mating surfaces column and tray where
frame will sit now screw through pre drilled holes.
For the latest fitting instructions please visit www.insigniarange.co.uk
Screw side to column here
Note side glasses have cut out
to overhang tray lip slightly at
rear
14