Yealink T41P User Manual page 95

In the following figure, the phone LCD screen shows an incoming call from 1001 on the
monitored line.
When there is an active call on the IP phone, you can transfer the active call to the
monitored phone number directly by pressing the BLF key. The phone transfers the
active call differently depending on the transfer mode on DSS key. For more information
on performing call transfer, refer to
To configure the transfer mode on DSS key via web user interface:
1. Click on Features->Transfer.
2. Select the desired transfer mode from the pull-down list of Transfer Mode Via Dsskey.
Depending on your selection:
If you select Blind Transfer, press the BLF key to blind transfer to the monitored
-
phone number.
If you select Attended Transfer, press the BLF key to dial out the monitored
-
phone number and then you can perform the attended or semi-attended
transfer.
If you select New Call, press the BLF key to place a new call to the monitored
-
user.
3. Click Confirm to accept the change.
Note
You can configure the transfer mode on DSS key via web user interface only.
Call Transfer on page 78.
Advanced Phone Features
91