Wiring Type And Length - Panasonic VL-V900 Installation Manual

Wiring
3

3-6. Wiring type and length

Control box
Control box
Control box
Repeater mode
the distribution box
that is operating
as a repeater
Distribution box
Control box
Power supply unit
Power supply unit
Lobby station
- Use 2-conductor (solid copper) wiring with a PE (polyethylene)-insulated PVC jacket.
Mid-capacitance, non-shielded cable is recommended.
- A certified power supply wiring has to be used with this equipment. The relevant national installation and/or
equipment regulations shall be considered. A certified power supply wiring not lighter than ordinary polyvinyl
chloride flexible wiring according to IEC 60227 shall be used.
- When connecting an electric lock to the electric lock connection terminal (K-OUT), select a device that meets the following
guidelines.
– N/C or N/O dry closure contact
– 12 V AC/DC, less than 1 A
Wiring run
<--> Lobby station
Distribution mode
<-->
the farthest distribution box
Repeater mode
the distribution box that is
<-->
operating
as a repeater
Distribution mode
<-->
the farthest distribution box
<--> Main monitor
<--> The farthest lift controller
Lobby station
Control box
<-->
Distribution box
Lift controller
<--> AC power source
<--> Electric lock
Wire diameter Max. length
0.65 mm (22 AWG) approx. 100 m
1.2 mm (17 AWG) approx. 200 m
0.65 mm (22 AWG) approx. 100 m
1.2 mm (17 AWG) approx. 200 m
0.65 mm (22 AWG) approx. 100 m
1.2 mm (17 AWG) approx. 200 m
0.65 mm (22 AWG) approx. 100 m
1.2 mm (17 AWG) approx. 200 m
0.65 mm (22 AWG) approx. 100 m
1.2 mm (17 AWG) approx. 200 m
0.65 mm (22 AWG) approx. 100 m
1.2 mm (17 AWG) approx. 200 m
0.65 mm (22 AWG) approx. 10 m
2 mm (12 AWG) approx. 20 m
1.2 mm (17 AWG)
No requirement
2 mm (12 AWG)
0.5 mm (24 AWG)
According to specification of
connected device.
1.2 mm (17 AWG)
32