Wiring Schematic Diagram - Panasonic VL-V591 Installation And Operation Manual

Installation

Wiring schematic diagram

Set up correctly according to the following wiring schematic diagrams and "Wire type and distance" (page 11).
20 main monitor stations can be connected to terminals 1 to 20 on the lobby station.
L F or main monitor station system, refer to the operating instructions of the main monitor stations. An example is shown
below.
Example: Connecting to terminal 1
Terminal
number
Lobby station (lower cabinet)
(Non
polar)
Power supply unit
Power plug
(220 V – 240 V AC)
*1  C onnecting the lobby station to the main monitor stations
L B e sure to perform the following to ensure proper operation:
– Connect terminal D1/D2 of each numbered terminal (1 - 20) on the lobby station to the wire from D1/D2 on the
main monitor station.
– Connect terminal S1/S2 of each numbered terminal (1 - 20) on the lobby station to the wire from S1/S2 on the
main monitor station.
*2 Connecting the lobby station to a door opener (for common entrance)
L B efore connecting to a door opener, make sure that:
– K1/K2 terminal: Normally open/Actively short
– The door opener is less than 30 V AC (1 A), 24 V DC (1 A). Do not connect to a door opener that is more than 30 V AC
(1 A), 24 V DC (1 A), otherwise the unit may be damaged.
– K1/K2 terminal on the lobby station is not the power supply to the door opener. If the door opener needs a power supply
device to connect to the lobby station, contact the dealer where you purchased the door opener.
L After connecting the door opener to the lobby station, confirm that the door can be properly locked/unlocked using the
main monitor station depending on the status of the door opener (page 11).
If you have set a PIN (page 14), confirm that the door can be properly locked/unlocked using the PIN depending on the
status of the door opener (page 15).
10
D1
D2
1
S1
S2
(Non polar)
Main monitor
KEY
K1
K2
(Non polar)
Main monitor station system
(Non polar) (Non polar)
station *
1
(Non polar)
Door (Door Opener)*
2
(for common entrance)
Door station
PBX
Terminal box
(4-conductor
wiring)
(Door Opener)
(Non polar)
Door