Invalid Password Entry - GE T60 Instruction Manual

CHAPTER 4: INTERFACES
– Clearing the oscillography records
– Changing the date and time
– Clearing the breaker arcing current
– Clearing energy records
– Clearing the data logger
– Clearing the user-programmable pushbutton states
To enter the initial setting or command password:
1. Press the key until the
MENU
display.
2. Press the right arrow until the
MESSAGE
3. Press the down arrow until the
MESSAGE
4. Press the right arrow until the
MESSAGE
appears on the display.
 SECURITY

5. After the
CHANGE...PASSWORD
selection to "Yes."
6. Press the key and the display prompts you to
ENTER
7. Type in a password and press the
8. When
VERIFY NEW PASSWORD
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
9. When the
NEW PASSWORD HAS BEEN STORED

4.2.11 Invalid password entry

By default, when an incorrect Command or Setting password has been entered via the front panel three times within five
minutes, the
LOCAL ACCESS DENIED
access via the front panel for five minutes.
By default, when an incorrect Command or Setting password has been entered via any external communications interface
three times within five minutes, the
settings or command access via the any external communications interface for five minutes. The
FlexLogic operand is set to "Off" after five minutes for a Command password or 30 minutes for a Settings password.
These default settings can be changed in EnerVista under Settings > Product Setup > Security.
T60 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
header flashes momentarily and the
SETTINGS
message appears on the display.
ACCESS LEVEL
CHANGE LOCAL PASSWORDS
CHANGE SETTING PASSWORD
ACCESS LEVEL:

Restricted
 CHANGE LOCAL

 PASSWORDS
message appears on the display, press the
ENTER NEW PASSWORD
key.
ENTER
displays, re-type the password and press
ENTER NEW
PASSWORD: ##########
message appears, your new Setting (or Command) password is active.
FlexLogic operand is set to "On" and the T60 does not allow settings or command level
FlexLogic operand is set to
REMOTE ACCESS DENIED
FRONT PANEL INTERFACE
message appears on the
PRODUCT SETUP
message appears on the display.
or
CHANGE COMMAND PASSWORD
CHANGE COMMAND

PASSWORD: No
CHANGE SETTING

PASSWORD: No
up or down arrow to change the
VALUE
.
.
ENTER
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
On and the T60 does not allow
" "
REMOTE ACCESS DENIED
message
4
4-59