FRONT PANEL INTERFACE
4.
Slide the new LED label inside the pocket until the text is properly aligned with the LEDs, as shown.
To remove the user-programmable pushbutton labels from the T60 front panel and insert the custom labels:
1.
Use the knife to lift the pushbutton label and slide the tail of the label tool underneath, as shown. Ensure that the bent
4
tab points away from the relay.
2.
Slide the label tool under the user-programmable pushbutton label until the tabs snap out as shown. This attaches the
label tool to the user-programmable pushbutton label.
4-46
T60 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES