IBM Eserver pSeries 670 User Manual page 142

Step 15
This step loads the standalone diagnostics.
1. If you are running one or more logical partitions, reboot the partition.
Note: Standalone diagnostics may be run with a CD-ROM or from a NIM server. If
2. Insert the diagnostic CD into the CD-ROM drive.
3. When the keyboard POST indicator displays, press the numeric 5 key on the
keyboard to indicate that diagnostics are to be loaded.
4. Type the requested passwords.
5. Follow the instructions to select a console.
Did the Diagnostics Operating Instructions display without any obvious display
problem?
NO
YES
Step 16
The diagnostics did not detect a hardware problem. If you still have a problem, contact
your service organization.
Eserver pSeries 670 User's Guide
126
run from CD-ROM, the CD-ROM drive must be made available to the
partition upon which you want to run standalone diagnostics. After this is
done, go to step 2. If running from NIM, the NIM server must be set up to
allow a diagnostic boot from that partition (both NIM server and client
partition must have network adapters). For more information, see Chapter 5,
"Using the Online and Standalone Diagnostics" on page 73.
Go to "Step 7" on page 123.
Go to "Step 9" on page 123.