THE TRANSMITTER'S FUNCTION SELECTIONS AND LED INDICATIONS
It is possible to program the function selection on the transmitter.The two yellow LEDs on the transmitter
indicate which receiver/receivers, relay group/groups or the lift on an overhead crane are to be controlled. By
setting the receiver's function selector switch at the same time a number of different types of relay functions
can be selected (see chapter "The receiver's function selection/relay functions").
Once you have programmed the function selections 1-3 the transmitter's LED 1 will always light when the
transmitter starts.
NOTE! As standard the transmitter is supplied with function selection 0.
FUNCTION SELECTION 0:
With function selection 0 it is only possible to control one receiver.The two yellow LEDs are not used.
The transmitter's function selection 0 matches with receiver's function selection; A, B, C, K, Q, R
FUNCTION SELECTION 1:
Using function selection 1 you can control two receivers (receiver 1, receiver 2 or both simultaneously), alter-
natively you can control two lifts on an overhead crane (lift 1, lift 2 or both lifts simultaneously).
By pressing button 7 the yellow LED 1 lights, press button 8 and the yellow LED 2 lights. Press buttons 7 and 8
simultaneously and the LEDs 1 and 2 light.
The transmitter's function selection 1 matches with receiver's function selection; D, G, I, L, N
FUNCTION SELECTION 2:
Using function selection 2 you can control two receivers (receiver 1 or receiver 2, but never simultaneously),
alternatively you can control two lifts on an overhead crane (lift 1 or lift 2 but never simultaneously).
By pressing button 7 the yellow LED 1 lights, press button 8 and the yellow LED 2 lights.The yellow LEDs 1 and
2 can never be lit simultaneously.
The transmitter´r function selection 2 matches the receiver's function selection; E, H, J, M, O
FUNCTION SELECTION 3:
With function selection 3 you can control two receivers (9 single functions on each receiver) or one receiver
(9+9 single functions).
By pressing button 10 (right start button) you switch between lighting the yellow LED 1 or LED 2.The yellow
LEDs 1 and 2 can never be lit simultaneously.
The transmitter function selection 3 matches the receiver's function selection: F, P
218