Transmitter - Tele Radio 860 Manual

TRANSMITTER

Pictures of the transmitter can be found on the fold-out page.
Technical Specifications
860TX-10
Stop button
10 two way push buttons
Internal rechargeable battery
Radio: PLL Synthesizer
69 different frequencies, 433.075 - 434.775 MHz
Enclosure size: 160x70x35 mm
Weight: approx. 270 g
Enclosure class: IP 54
HOW TO START THE TRANSMITTER
1. The stop button must be pulled out.
2. Press the start buttons simultaneously for at least 1 second.
3. Release the start buttons.
4. LED 3 is lit green to indicate the transmitter is running.
HOW TO START A TRANSMITTER WITH A PIN CODE
1. The stop button must be pulled out.
2. Press the start buttons simultaneously for at least 1 second.
3. Release the buttons.
– The yellow (2) and green (3) LEDs flash.
4. Enter the PIN code (4 numbers).
– The green LED (3) lights continuously.
If the wrong PIN code is entered the transmitter will switch itself off.
HOW TO TURN OFF THE TRANSMITTER
To turn off the transmitter press the stop button.All relays in the receiver are disconnected when the stop
button is pressed on the transmitter.
HOW TO CHARGE THE TRANSMITTER:
Pictures of charging the transmitter can be found on the fold-out page.
•
The 860TX-10 transmitter is supplied with an internal rechargeable battery and an integrated charger.
•
The 860TX-12 transmitter is supplied with an external rechargeable battery and a charger unit.
The LED in the transmitter indicates red or green depending on the status of the battery.The operating time
for the transmitter is approx. 30 hours for the 860TX-10 and 20 hours for the 860TX-12 with continuous
usage.The LED (3) changes colour to red when it is time to charge the battery and approximately 10 % of the
battery capacity remains.
The LED in the 860TX-10 transmitter and in the 860TX-12 charger unit, will remain red during charging
(full charge time: approx. 4 hours) until fully charged when it changes colour to green.The battery can not be
overcharged.
NOTE! The life span of the battery increases if you wait until the LED changes to red before recharging. However, it
should be charged at least once every second month.
– Charging: 12V-35V DC (500 mA) or 230V AC via an adaptor.
860TX-12
Stop button
12 two way push buttons
External rechargeable battery
Radio: PLL Synthesizer
69 different frequencies, 433.075 - 434.775 MHz
Enclosure size: 210x80x40 mm
Weight: approx. 400 g
Enclosure class: IP 65
205