LG RNOE-B501A Owner's Manual page 37

Other
> UPnP Enable: Check the [UPNP Enable] box and restart the
device to enable the UPnP function.
> SNMP Enable: Check the [SNMP Enable] box and restart the
device to enable the SNMP function.
> HTTP Port: Enter the HTTP port, then restart device.
> HTTPS Port: Enter the HTTPS port, then restart device.
> RTSP Port: Enter the RTSP port, then restart device.
• Save: Save all the setup.
Note:
If the user changes setting of the HTTP, HTTPS, and RTSP ports, the
IP Device is rebooted. The rebooting time is approximately 2 minutes.
Operation and settings
IP Filter
Blacklist and whitelist also named [IP filter], used to manage the access
right of users.
> Setup IP filter.
- Forbidden: Cancel all the blacklist and whitelist.
- Blacklist: It used to block some IP address. Input the block IP
address and click [Add], [Save].
Note:
Please don't add your own IP address in blacklist, otherwise
you will not be able to login.
- Whitelist: Selects only some IP address allowed. Input trusted
IP address and click [Add], [Save].
Note:
Once enable the whitelist function, please make sure to add
your own IP address in whitelist, otherwise you will not be
able to login the device.
> Add: Add block IP address or trusted IP address according to
IP filter setting.
> Delete: Delete certain IP address. Select the left check box and
click [Delete].
• Save: Save all the setup.
Note:
The IP filtering can only recognize when the new user login, but
not work for ready IP. It is strongly recommended that restart the
equipment each time after configuring blacklist and whitelist.
37