Connection; Connecting Network; Connecting Power Source; Connecting Microphone And Speaker Device - LG RNOE-B501A Owner's Manual

Connection

Precautions
• Be sure to switch off the unit before installation and connection.
• The installation should be made by qualified service personnel or
system installers.
• Do not expose the power and connection cables to moisture, which
may cause damage to the unit.

Connecting Network

You can control and monitor the system via network. With the remote
control (monitoring), you can change the system configuration or monitor
the image via network. After the installation, check the network settings
for the remote control and monitoring work.
Connect the IP camera to your network using a standard RJ-45 network
cable as shown below.

Connecting Power Source

Connect power, using one of the methods listed below:
To use the power adapter
Connect AC 24 V power source to the power input terminal as shown
below. (recommended power adapter is AC 24 V / 3 A or above).
A
B
C
No. Description
AC 24 V 1
A
B
AC 24 V 2
C
10

Connecting Microphone and Speaker Device

Optionally connect an active speaker and/or external microphone with
a built-in amplifier.
Note:
Keep the microphone away from the speaker to avoid howling.
Broadband

Connecting Alarm Device

Service
Alarm terminals are used to connect the alarm (relay) devices such as
sensors, door switches, etc.
ALARM IN & OUT / ALARM IN & OUT Ret
Connect the sensor device to the sensor input terminal and ground
(GND) terminal. Use the ground (GND) terminal when you need to
connect the sensor device.
Connect the alarm (relay) device to the relay output terminal. Alarm
signal is outputted at an event occurrence.
Color
RED
No.
YELLOW GREEN
A
GREEN
B
C
D
AUDIO IN
GND
AUDIO OUT
Color Description
PURPLE
BROWN AUDIO OUT
GREEN
ALARM OUT
A
B
C
D
ALARM IN
Description
ALARM IN 1
ALARM GND
ALARM OUT 1 WHITE BROWN
ALARM OUT COM
AUDIO IN
GND
Alarm (relay)
Device
Sensor
Device
Color
RED
BLUE
WHITE BLUE
Installation