LG RNOE-B501A Owner's Manual page 29

[Behavior Analysis]-Event Set: [Perimeter]
> Enable Arithmetic: Behavior Analysis
> Rule ID: Select rule number.
Note:
Check the [Valid]. It draws one rule lines, the arrow of line means
direction of prohibit crossing.
> Event Set: Select [Perimeter].
> Detection mode:
-
[Intrusion] mode: It will trigger alarm when object stay in
detection area until reach [Invasion Time].
- [Enter] mode: It will trigger alarm when object go to
detection area.
-
[Leave] mode: It will trigger alarm when object go out
detection area.
> Invasion Time: Setup invasion time of object stay in detection
area, it will trigger alarm when over the time.
> Sensitivity: Adjust sensitivity value. As value increases, more
sensitive.
• Save: Save all the settings.
• Next: Go into [Alarm Setup] menu.
Operation and settings
[Behavior Analysis]-Event Set: [Object Abandon]
> Enable Arithmetic: Behavior Analysis
> Rule ID: Select rule number.
Note:
Check the [Valid]. It draws two rule lines. The arrow of line means
direction of prohibit crossing, 2 lines direction should be the
same, it will alarm when target object cross 2 lines continuously
within the specified time.
> Rule Name: Input a rule name.
> Event Set: Select [Object Abandon].
> Alarm Time: Setup alarm time of object stay in detection area,
it will trigger alarm when over the time.
> Sensitivity: Adjust sensitivity value. As value increases, more
sensitive.
• Save: Save all the settings.
• Next: Go into [Alarm Setup] menu.
29