Siemens 3VA1 100 A Manual page 235

Cable cage
Cable cages are used to attach the breaker-end half of auxiliary circuit connectors to the
molded case circuit breaker. They are also designed to act as cable ducts for installing wires
from internal accessories to the auxiliary circuit connector. For further information about
cable cages, please refer to chapter Auxiliary circuit connector (Page 231).
Cable cages consist of a top half and a bottom half. These parts are designed such that they
cannot be mounted in the wrong position at the rear of the molded case circuit breaker.
Cable cages are included in the scope of supply of the conversion kits and complete kits for
converting molded case circuit breakers to plug-in or draw-out units and are therefore also
supplied with complete kits. They are available as standard only in the broadened version for
4-pole units. For use on 3-pole units, part of the cable cage need only be cut away (at the
required breaking point).
3VA molded case circuit breakers
Manual, 04/2015, A5E03603177010-02
4.4 Plug-in and draw-out technology
Accessories
235