Siemens 3VA1 100 A Manual page 190

Accessories
4.3 Connection system
Rear terminal flat
The rear terminal flat can be installed to connect busbars and cable lugs to the rear panel of
a 3VA molded case circuit breaker.
The rear terminal flat can be rotated in steps of 45°, i.e. it can be installed an an angle of 0°,
45° or 90°:
The dimensions of rear terminals flat are given in the table below:
Rear terminals flat can be ordered
● as a pack of 3 (2 short terminals flat and 1 long terminal flat)
● as a pack of 4 (2 short terminals flat and 2 long terminals flat)
● as a pack of 1 (1 short terminal flat)
● as a pack of 1 (1 long terminal flat)
Note
In order to achieve degree of protection IP40, terminal covers (flat version) must also be
attached when a rear terminal flat is installed.
190
3VA molded case circuit breakers
Manual, 04/2015, A5E03603177010-02