Configuring Static Ip Connection; Configuring Dynamic Ip Connection - Compex CGX3224 User Manual

Chapter 7 Configuring Your Wide Area Network
7.3

Configuring Static IP Connection

Procedures
1. Go to WAN Config at Command Window, click on the pull-down menu from the
WAN Port field.
2. Next, select Static IP Address from the pull down menu at WAN Type field.
You may enter your IP Address, Subnet Mask and Gateway IP Address in the
individual fields. All these information can be obtained from your ISP/Network
Administrator.
3. Click on Save button to update the data.
The WAN Setup screen shows a Static IP Configuration that allows you to configure
your Static IP connection to your ISP.
7.4

Configuring Dynamic IP Connection

Compex CGX3224 uses Dynamic IP as the default WAN type. Hence, if you are using
Cable Internet, you do not need to configure the WAN connection.
However, if your account requires a DHCP Client ID in order to release an IP address,
you may need to configure the name of Compex CGX3224 with the DHCP Client ID
issued by your ISP.
See the section on "System Configuration" on Page 62, and remember to enter the
DHCP Client ID issued by the ISP into the System Name field in the System Identity.
33